Results 1 to 3 of 3

Thread: Another Question/Problem

  1. #1

    Another Question/Problem

    I am engraving aluminum flat bar. When the text is normal on my screen the text engraves like I'm looking at it in a mirror.

    If I mirror the text as shown in the pic it engraves correctly. I looked thru settings and didn't see anything that I could change to make the engraving look like what I see on the screen.

    What do I need to change so that what's on the screen engraves on the flatbar?

    Thanks!
    Attached Images Attached Images
    Last edited by Nick Marchesani; 08-31-2020 at 3:40 PM.

  2. #2
    F3 button-

    upper section, check if glavo 1 or glavo 2 is "X" - It's likely galvo 2-

    lower section is the settings for each galvo. There's a check box in each galvo section , NEGATE. If your galvo 2 box is checked, un-check it (or vice versa.)

    NEGATE flips the axis...
    ========================================
    ELEVEN - rotary cutter tool machines
    FOUR - CO2 lasers
    THREE- make that FOUR now - fiber lasers
    ONE - vinyl cutter
    CASmate, Corel, Gravostyle


  3. #3
    Quote Originally Posted by Kev Williams View Post
    F3 button-

    upper section, check if glavo 1 or glavo 2 is "X" - It's likely galvo 2-

    lower section is the settings for each galvo. There's a check box in each galvo section , NEGATE. If your galvo 2 box is checked, un-check it (or vice versa.)

    NEGATE flips the axis...
    I was wondering where you were! I thought that you would know what to do and you were right!
    Thanks a Million!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •