Making some progress on a long neglected project to convert an amplifier from a Printed Circuit Board build in a metal box to being point-to-point wired in wood. Neanderthal only in the use of vacuum tubes. All the machining by way of table and chop saw except for hand-planing the faces and chopping the opening for the AC power/Fuse module at right rear with mallet and chisel. The wood is Sapele, which, translated from the Urhobo means, "must wear mask while machining".
I'm debating whether to add splines or 1/8" dadoes all the way round for some visual interest. Other than that, ready now for the wire-up.
IMG_4997.jpg
IMG_4998.jpg
IMG_5000.jpg