Stanley No. 20, 8" square. Needed adjusted for square ( been dropped a few times?) Hammer adjusted until it was indeed square.
Still need to refinish the wood part, but..
August Yard Sale 1, Stanley No. 20 square.JPG
Instead of brass holder for the three pins, these are steel, as well as the 3 pins. A brass wear plate is held on to the wooden handle with 3 slotted steel screws, counter-sunk into the brass strip.
Logo side of the blade; readable numbers count towards the handle....non logo side, the count away from the handle.
That "chef's hat" screwdriver is by Goodell Pratt Co.
August Runt Hunt, cute ones.JPG
Not sure about the tiny one. The spanner screwdriver has MAC SABINA, O. Patented...may use it for those split nut saws I have.
Last screwdriver seems to be your run-of-the-mill Stanley.
August Yard Sale 1, clean up1.JPG
These two, rust and tarnish have been cleaned up. Finally got the Yankee chuck to release the bit....spring seems a bit sluggish ( may have broke?) except for the last 2" of travel. Red Handle has two sizes of Phillips drivers...the 3 square drive bits seem to be too fat to use.
August Yard Sale 2, Chisels.JPG
These 3 showed up, today...counting a 1/2" Pony clamp...
August Yard Sale 2, Pony Pipe Clamp.JPG
Cost me $3 for the lot.....Chisel set (England) is missing the 12mm sized chisel.
have another D-8 to rehab.....a 10ppi Disston/HK Porter...
August Yard Sale 2, medallion.JPG
Price was right, at least..
August Yard Sale 2, price tag.JPG
Nothing cracked, nothing bent, no missing teeth....Handle even fits my hand....26" long..
August Yard Sale 2, D-8, 10 ppi.JPG
Not too bad of a morning?