Results 1 to 5 of 5

Thread: Shop made sliding table for bandsaw

  1. #1
    Join Date
    Dec 2010
    Location
    South Coastal Massachusetts
    Posts
    6,824

    Shop made sliding table for bandsaw

    After a lengthy resawing session (by hand) in my last project, I decided to return a bandsaw to the mix.
    This time, I found one with standard house power requirements that fit in my basement.

    Izzy Swan and Mr. V provided the impetus to add a sliding table.
    Izzy used a stock tablesaw sliding table, but I balked at the cost.

    Mr. V's approach allowed me to assemble piecemeal, bodging things as I went along.
    My version uses cheapo linear bearings from Amazon, scrap 1/2" plywood a scrap drawer and more screws than I can count.

    The most difficult part of this build was figuring how to affix the sliding table section without a direct fixture to the bandsaw.
    The only mechanical connection is a delrin strip in the stock cast iron base.

    A shop cart was pressed into duty to support the works. It would be *much* easier to build the sliding table assembly then construct legs underneath.

    Using available drawers and building a flat torsion box assmebly allowed me to get things flat and dialed in.

    Once the saw was running straight and true, the first part of the sliding top was attached, and run through the blade. This establishes the cutline, just as with a tracksaw.
    The second sliding top piece was then squared (using the first piece as a template) and attached.

    The "fixed" side of the table is held down from beneath the stock cast iron table with a couple blocks and a scrap length of Oak spanning the base.
    The fixed side is supported on additional blocks from beneath and by a plywood strut assembly, to act as an outfeed table.

    It came out surprisingly flat.

    The end stop was squared to the cutline and a sacrificial fence attached.
    To manage long rips, the end stop has a relief allowing up to 22" wide boards through.

    Max run of the slider between the stops is 18".

    An auxiliary fence can be clamped to either the end stop of the fixed table.

    Maximum clearance under the guides is almost 10".

    Testing on the 5 cut method yielded and error of .3mm per side - less than the width of my marking pencil.
    It'll do.

    P1070031.jpg
    https://imgur.com/a/bLrcA2V
    Last edited by Jim Matthews; 08-07-2020 at 10:49 AM. Reason: Placement of link

  2. #2
    Join Date
    Mar 2005
    Location
    Cashiers NC
    Posts
    603
    Nice job. One of my favorite tools is a mortiser I built myself. Can you just set it off when you need to cut thicker stock?
    Last edited by Charlie Jones; 08-07-2020 at 10:44 PM.
    Charlie Jones

  3. #3
    Join Date
    Dec 2010
    Location
    South Coastal Massachusetts
    Posts
    6,824
    It *could* be taken off, but the top layer is only 1/2".

  4. #4
    Join Date
    Mar 2005
    Location
    Cashiers NC
    Posts
    603
    I was looking at the top picture. It looked a lot thicker.
    Charlie Jones

  5. #5
    Join Date
    Oct 2007
    Location
    Coastal Southern Maine
    Posts
    350
    That is absolutely fantastic. Great solution. I love the knowledge & ingenuity of SMC.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •