I have an older Unisaw (model 36-816) and I need to remove the stud that is attached to the angle hand wheel. I am installing a router table wing on the left side of the saw, and because it is a right tilt saw, I have a clearance issue with the stud that sticks out of the angle hand wheel. Does anyone know how to get that stud off the hand wheel? It has a plastic cover on it that spins, but there are no set screws or Allen heads visible. I’m trying not to destroy it in case I will ever need to reinstall it. Appreciate any help.
DFCAD2B0-2290-42CA-9426-17C71F875CEF.jpg