[OP]
Friend of the Creek
Hi Guys;
I am running RDCam v.8 on a twin head 130 watt/head Quantam laser (new) and, after much confusion, found that the RDCam software
has switched the ID's of the heads. machine Laser 1 is software Laser 2 and vice versa. No problem when settings are the same for both lasers but a mess when tweaking settings if you are unaware of the switch. Anyone know how to change the software designations?
Thanks
*twin 80 watt Shenhui 1280
*60 watt Laserpro Mercury -42ips
*(2) 30 watt Laserpro Venus-42 ips
*whole bunch of woodworking/metalworking machines
*128 screwdrivers (all needed)
*wonderful wife (1st) of 53 years who allows me to collect screwdrivers
Member
Can you change it in the vendor settings
[OP]
Friend of the Creek
Jerome;
I looked at that and can't find anywhere to switch them. Not sure how RDCam decides which is which.
Thanks
Best regards;
GM Perzel
*twin 80 watt Shenhui 1280
*60 watt Laserpro Mercury -42ips
*(2) 30 watt Laserpro Venus-42 ips
*whole bunch of woodworking/metalworking machines
*128 screwdrivers (all needed)
*wonderful wife (1st) of 53 years who allows me to collect screwdrivers
[OP]
Friend of the Creek
Exchange CN5 and CN6 plugs on controller board- all OPK
Best regards;
GM Perzel
Laserarts
*twin 80 watt Shenhui 1280
*60 watt Laserpro Mercury -42ips
*(2) 30 watt Laserpro Venus-42 ips
*whole bunch of woodworking/metalworking machines
*128 screwdrivers (all needed)
*wonderful wife (1st) of 53 years who allows me to collect screwdrivers
Posting Permissions
Reply With Quote