I had a SawStop event today which triggered the safety. First time I had run the saw since removing the dado set. I had one of the red Freud blades on it that had just had a tooth replaced due to a previous meat head move (the last 6” of an 8’ 2x6 were wet). My SIL who is a fine guy but very inexperienced in a shop helpfully ran a tape across the table for some reason while the saw was running, but the tape hit the blade and boom. SawStops are very reliable. Operators and observers, not so much. I am very careful in cartridge installation. I cannot figure what happened here today. I fired up the saw and was cutting an 18” Cedar 1x6. Got about a foot into it and it triggered. I just ordered two new cartridges. Having only a single apparently does not work. If things ever open up again and the woodworking shows open up you can recognize me by the necklace of Blue Springs I will be wearing...If I can keep them away from the Grandkids. So proud! Just so proud!