Well....I did have a stack or two of scraps...
Ash scraps , 2.JPG
And a couple of Pine boards sitting around, doing nothing constructive
Pine scraps.JPG
And a couple handy panels of plywood....
Plywood supplies.JPG
That needed a job. Sorted through the Ash scraps....had 11 pieces, tossed out 2...They needed squared up, so they were all about the same width, will worry about the ends, later. Process made quite a it of saw dust...
July Project, sawdust maker.JPG
Then set up the zero clearance overlay...
July Project, resaw set up.JPG
Used a bit of scrap to center the blade into the middle of the 9 boards...run each through along both edge grain sides....
July Project, resaw blanks.JPG
But, height of cut was NOT enough that a pass both ways would reach deep enough.....had to set up the bandsaw...
July Project, old blade.JPG
Which left that strip to plane off....later. May change out to a wider blade, later....
July Project, new blade.JPG
As I have wider stock to do....at least I have a start.

Seems a couple boxes with drawers have been outgrown. Will see about a slightly larger version....
Stay tuned...