Results 1 to 3 of 3

Thread: PM 66 motor removal, tips or advice?

  1. 07-09-2020, 7:38 PM #1
    Lloyd McKinlay
    Lloyd McKinlay is offline [OP] Contributor
    Join Date
    Dec 2005
    Posts
    328

    PM 66 motor removal, tips or advice?

    The motor on my 1986 PM 66 requires repair. At first glance it appears to be a straightforward procedure but we all know things are often not what they seem. Any advice or suggestions to make removal and replacing as easy and trouble free as possible?
    Reply With Quote Reply With Quote
  3. 07-09-2020, 8:29 PM #2
    Bill Dufour
    Bill Dufour is offline Contributor
    Join Date
    Sep 2016
    Location
    Modesto, CA, USA
    Posts
    9,969
    If that is the table saw it is a c-mount motor. You may have to remove the pulley first. I would cut the power cord as close to the motor as possible. Add a short pigtail cord at the bench. Ad a inline female receipticale on the stub cord left on the machine.
    Bill D.
    Reply With Quote Reply With Quote
  4. 07-09-2020, 10:47 PM #3
    Chris Sherwood
    Chris Sherwood is offline Member
    Join Date
    Jun 2020
    Location
    Charlottesville Va
    Posts
    41
    https://www.mmtoolblog.com/post/pm66...ent-3ph-to-1ph

    This might help. I just removed mine, but it was the first time so I don’t qualify as an expert.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules