Hello,
I am looking for advice. My ultimate goal is to run RJ45 cable in 2 of my exterior walls (from a ethernet outlet) down into my basement and over my drop ceiling and back up through the closet wall to where my network switch will be located. I don't know alot about construction but am trying to figure out if i cut a opening for the outlet in the wall and use a flex bit to go down, wont I hit the bottom sill that the subfloor and ultimately the outside wall rest on? I see the bottom sill is on top of the foundation wall, which if I'm understanding this correctly its not where I want to be. I hope your understanding what I'm trying to say. Does the exterior wall sit in from the foundation (sill) or when constructing a house, is the wall directly on top of the foundation (sill)? I want to route the wire in the wall but once I drill though the subfloor, is the sill and foundation directly beneath it then, if so, how can I get my wire into the basement. Thank you