Dovetailing Journey

[Bill Carey]

Rob, I’m celebrating with you. Nice work. Write the date on the inside of that one.

2nd that! And keep it on a shelf in your shop. Well done!

[Erich Weidner]

Hoping I can figure out why these photos always come in at 90* to how I want them

It is a defect in the forum software (well... rather it is the software developer taking a ridiculous position as to if images should be auto rotated).

https://sawmillcreek.org/showthread....ideways-on-SMC

[Clifford McGuire]

I made one of these this morning and tried using blue tape on the end of the pin board. Epic fail. For whatever reason the tail sockets were oversize. I could assemble right off the saw but there were huge gaps everywhere. I decided a break was in order so I took my bride to lunch.

Looking good!

I have the opposite problem. Using blue tape gives me overly tight pins. I think I'm careful with the marking knife. And I place the saw such that I'm just leaving the tape. The pins turn out too tight and I end up paring a bit off of them.