Results 1 to 2 of 2

Thread: G Weike LG6040N USB Dongle Driver and Software

  1. #1

    G Weike LG6040N USB Dongle Driver and Software

    Hello,

    I have a G Weike LG6040N that has never been used. It is from the 2014 timeframe. The USB dongle is labeled 2013 and WHCX-LASER1. If memory serves, the control board is a Leetro MPC6515. Pics of the dongle, board, and control panel are attached.

    My Windows 8 machine is not recognizing an appropriate driver for the dongle. Does anyone had an idea where I can locate a driver and ideally a newer version of Lasercut? Updated BIOS for the board would be a plus.

    Thanks so much in advance!

    BradIMG_0185.jpgIMG_0187.jpgIMG_0186.jpg

  2. #2
    I was able to find all on this on Leetro's site. Any idea where I can find the config file for this unit? I seem to remember you could read this from the machine.

    Thanks!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •