Hi everyone,

For the past 2yrs we have been consistently cutting 1/4" mdf with our Speedy400 (80w) every day. Upon firing up the laser Monday something had changed - it was no longer cutting consistently throughout the whole job. Some areas would cut through while other areas barely, and some not at all. Slowing the speed way down didn't seem to help either. Just had the tech out today to check table for level and alignment which is all good. Power at the table was measured in a number of areas and is still where it needs to be. He is going back to check with the service manager to problem solve but I thought I would check in here to see if anyone has experienced this problem before.

fyi typically we would run jobs at 100% power, .30 speed. Now I can't even cut through at .12 speed.

Any thoughts/comments would be appreciated!