Does anyone have a bathroom vanity plan - ideally about 42" wide?
Does anyone have a bathroom vanity plan - ideally about 42" wide?
A typical face frame cabinet plan will work. You may need adjustments for plumbing and bowl. Can you take measurements from an existing cabinet? Made mine from cherry with panel end. The other end is against a wall.
Rustic? Well, no. That was not my intention!
I made a similar sized vanity for my son and his wife. I have a cad drawing of this vanity that is 42" if you would like it.
IMG_4412.jpg
The doors and drawers are inset to the face frame.
Last edited by Lee Schierer; 06-21-2020 at 8:06 PM.
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute
My wife has said that modern (1970's onward) vanitys and kitchen cabinets the drawers are too tall. One on the bottom for upright shampoo bottles 3-4 above it only 2-3 inches tall. Other wise stuff gets buried in the drawers. A proper machinist tool box will follow this design.
Our 1949 kitchen and bath cabinets have four drawers. Modern ones would only have three or even two drawers to save on hardware costs.
Bill D.
Here is the cad file for the 42 inch vanity.42 in vanity.dwg
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute