After taking some advice here, I found that I love the MM4.
I've learned some things and have a question.
First, I've made a spraybooth in the garage -- spraying outside was a mistake. It was easy for dirt to get on my workpiece and things dried too fast in the sun. Second, I was super glad I bought the whip hose and also a remote to start/stop the machine. That has been great. I've had to dilute the advance to about 15% to get the 30 second run rate from my #4 ford cup recommended by Fuji for the 1.5mm head.
Questions:
1. Cleaning -- I am obsessive about cleaning right after spraying. Every time I fully disassemble the gun. I'm curious about how much I could wait -- could I leave the advance in the MM4 cup and clean later? Could I just run water through the cup and then do a full cleaning the next day? How much does waterborne vs oil-based matter?
2. Final finish. After spraying the advance, it didn't match the sheen of the factory finish on the cabinets I got. I'm thinking about general finishes topcoat to get a bit more of the sheen of the factory finish. I also ordered EMTECH HSF5000 WB Primer/Surfacer/Filler and EMTECH EM6500 (custom tint). I am hoping that might work better.
3. Primer -- I used BIN which I found I could easily spray and sand (using LVLP gun) I didn't want to use BIN in my Fuji gun. But the local BM dealer recommended Zinsser Oderless primer, which I will try on on my next piece, does this make sense?