My Craftsman saw will not return to 90 degrees. I turned it to tight and the stop went to far into the housing... I put everything back the way it was and now it will not return to 90. Please manual page and picture of the mechanism.
I loosened the stop against the side of the housing and pulled it off the housing and left it loose. I loosened "C" and then adjust loose "D", but it will not move more towards 90. There is a set screw in the little gear that nut "D" sits next to. Can I loosen this set screw and then turn this gear a little to give me more range of movement and then set everything tight to the new gear mesh setting? Appreciate any help.
Thanks.
BrianCraftmans tilt mech.jpg
Reply With Quote