Results 1 to 1 of 1

Thread: Thanks Carole Scott

  1. #1

    Thanks Carole Scott

    I just bought a refurbed win 10 laptop as my old Dell win 7 was dying . Carole sent me all the links to install drivers and new lasercut software. After I did that I must of messed something up as the laser would not respond to commands. Carole spent a couple hrs on the phone yesterday and today walking me thru the setup and then troubleshooting the problem after it didn't work. Glad to say I'm up and Running again .
    So Thanks Carole at Rabbit Laser USA
    Last edited by Mike Null; 05-14-2020 at 10:44 AM.
    If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
    Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
    Lasercut 5.3
    CorelDraw X5

    10" Miter Saw with slide
    10" Table Saw
    8" bench mount 5 speed Drill Press
    Dremel, 3x21 Belt Sander


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •