Finally got a good blade on the 1412, made some test cuts and adjustments, all seems good except the fore/aft square check is off with about 1/16” gap at the bottom the blade, ( need to adjust the back end of the trunion up for it to be perfect) how critical is this adjustment? To me it seems that the blade will just enter the cut at the table end of the wood first vs being equal at top and bottom. Will that have an effect on any other aspect of the cut? Adjusting the table for fore/aft truing is a bit of a pain with the table in place as the trunion needs to be adjusted. Is it worth it for 1/16” ? Thanks for any help….