20200411_144836 (1).jpgbadcut.jpg
Ok here is the issue look at the cuts and on the roof how jagged the curves are. THe fact that the cut is not lining up with the etching.
So I sent this to Epilog of what I have done..
I have cleaned the lens, Replaced the encoder strip as itwas bad, Cleaned the encoder reader and flipped the white cable.

Epilogs response..
The issue could be something with either the rail being bad or the x motor. What I see happening is that it isn’t holding its position in the x in order to get a straight cut going in the y.
- Look for a loose x belt.
- Maybe remove The x motor and see if you can feel the pulley of it to determine whether that’s loose.
- Maybe the bearings in the rail is bad. Move the carriage every 5 inches and see if you can feel it loose?

I checked everything but can't seek to fix this.
I thought a new set of eyes might help.
The picture with the curved items was the second picture after the changes Epilog suggested.

Thank you