Hi folks,
I'm wondering if anyone can suggest a trick to aligning dominos for a butt joint in a 4x4 workbench frame that will look like this. These will be dry joints--I'll be using bench bolts centered in the joint to pull them together. (I may end up using smaller dominoes, but that's not relevant to my question.)
Left to myself, I'd either (1) plane the pieces so they are absolutely-positively-identical in height, and then use the fence to reference down from the faces on each side, or (2) use shims to reference UP from a flat surface. Is there another way I'm not seeing?
4domino 3.jpg4domino 4.jpg