Grammar
Grammar
The grammar is off a bit.
jtk
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
Assumption is the mother of all screw ups
Anonyms
I may be wrong, but in my opinion, that IS the earth in the distant sky, you can make out the continents...
The pic above is 'artwork', not a photo, so the size relationship shown isn't necessarily correct--
Regardless of all that-- What I find wrong is: the astronaut and the lunar module are casting shadows, but the flag is not...
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
If you look closely at the flag, you can see shadows in the correct locations from the waves in the flag, especially on the lower right corner of the stars...
2020-11-21 14_25_20-Window.png
This is a photo - not artwork.
That's an interesting point, there are shadows on the flag but done detectable on the ground.
Assumption is the mother of all screw ups
Anonyms
looks like the flag is blowing in the wind
It was designed that way, knowing there was no air on the moon...
Do not know if it was cloth with a wire on top to hold it out or if some other method was used...
Remember them doing it way back in 1969..
yes, I am old
I was visiting my brother in Pennsylvania.
Some things you remember forever...
Last edited by Ed Aumiller; 11-21-2020 at 8:01 PM.
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander
so yeah, I AM wrong, that IS the moon in the sky --
But yes, while the flag is casting shadows onto itself, it's not casting a shadow on the ground...
HOWEVER- since the moon is obviously photoshopped into the picture, my bet is the flag is too...
Kinda like THIS is
mcdpp.jpg
Last edited by Kev Williams; 11-21-2020 at 10:38 PM.
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander