Are there 3rd party suppliers for mirrors and lens for an Epilog mini 18 laser?
If so, have you used any you would recommend?
Thanks.
Are there 3rd party suppliers for mirrors and lens for an Epilog mini 18 laser?
If so, have you used any you would recommend?
Thanks.
Laser research optics (Providence RI) would have what you need.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
Tony, thanks for the reply. I checked them out, but it was cheaper to buy directly from Epilog which was suprising and the tech I have talked to at Epilog has been especially helpful.