I sincerely apologize as this has likely been discussed previously, but to avoid searching through the past posts, I would like to request any advice. I'm going to redo my present dust collection -
* I have a Delta 50-760 single bag unit
* I have installed a Thein collector/seperator
* I just ordered a Wynn canister (best model) to replace the upper bag
* I currently have about 12-14' of main trunk of 4" sewer drain PVC that runs parallel to a beam (basement shop)
* I have drops using 4" PVC and/or 4" flex hose to the table saw, jointer, planer, and miter saw.
I was thinking about replacing the 4" PVC with 6" as I recollect that bigger diameter is better. While doing this, is 6" metal (heat duct material) better than 7" PVC? Metal duct materials is much easier to get (at all borgs), but my focus is on what's best and I'll get the PVC if better.
Thanks in advance for any input.