Just started up...another one of my Build-alongs...
2 drawer chest, start up.JPG
Some of the parts....mostly 5/16" thick, from doing all that resaw work.
2 drawer chest, top parts.JPG
These two will get glued up into a lid...edges will get jointed, later will cut it to length.
2 drawer chest, ends jointed.JPG
The 2 pieces for the ends were jointed to match each other...but..
2 drawer chest, not square.JPG
Were not square on either end, and one was longer than the other...
2 drawer chest, mitre saw.JPG
They are square now, and the same length....the panel for the back was then cut for length...
2 drawer chest, ends and the back.JPG
Back needed ripped to match the width of the ends...I save the cut-off...have a plan for it..
2 drawer chest, front two parts.JPG
Will be the front of a Poplar drawer divider, between the two drawers...
Which brings us to Part II....stay tuned..