Resaw on the bandsaw or table saw?

[Paul F Mills]

Be prepared for the re-sawed stock to result in several very wavy boards. Depending on the drying process, you might not end up with usable "flat" boards.

There was some waviness, but not too bad. I knew that would happen so I cut it all at 1” so I could joint and plane as needed to get it to 3/4”.

The walnut was kiln dried so most of it came out stragiht. One piece warped a bit but I can straighten it when I do the glue up. The strange thing was that the offcut of the warped board did not warp, and it was thinner.