[OP]
Contributor
I’m looking to expand my cabinet shop capabilities to doors. I’ve found a couple of Powermatic 26 5hp 3phase shapers with 1” spindles that I’m going to pick up this week. Can the spindles be replaced with 1 1/4? Or will t bushings work well enough? I feel like they are pretty good deals. Any advice before I pull the trigger will be greatly appreciated.
Harmony is the strength and support of all institutions, especially this of ours.
Contributor
I have a Delta 43-375 with a 1" spindle. I use T-bushing adapters to run 1-1/4" cutters. Works fine.
"The first thing you need to know, will likely be the last thing you learn." (Unknown)
Member
Shannon bushing 1 1/4'' cutters is not a problem. I would research the Powermatic 26 shaper more. Not sure the spindle/bearings in these machines are heavy enough for the work you want to do. Others have posted here about issues with spindle cartridge/bearings not being big enough to handle heavier use.
Posting Permissions
Reply With Quote