-
Back "popped out" yesterday...still too sore to do much...like walk down the steps to the shop...let alone move the table around to top coat it...
Handle did have brass plating....that was starting to flake off...wire wheeled the rest of the Fake Brass off.....has a "Brushed Nickel" look to it, now.
Not sure IF I'll add any "foot pads" to the legs....first I'd have to buy a set.
May post as a completed Project...later...
-
One coat of Amber Shellac, 1 pound coat...has been brushed on...
Leftovers PIP, top shellaced 1.JPG
Taking a LONG time to dry in the shop..
Leftovers PIP, front view.JPG
Try again tomorrow for a second coat....should be dry, by then...
-
Steven,
I particularly like the grain match up from the top view, especially after you added the stain. Nice!
Stew
-
Thank you!
Brought the table upstairs....a lot warmer up here. Basement was a tad too cold...set the table to photo shoot....looking for the best light..
Leftovers, Project Post 4.JPG Leftovers, Project Post 5.JPG
Rotate around...grain seems to follow right along..
Leftovers, Project Post 3.JPG
And the front..
Leftovers, Project Post 2.JPG
Then the sunlight moved a bit, so..
Leftovers, Project Post 1.JPG
May post this last one over in the Projects page?
-
The Boss has "table-napped" this table....already sitting it's new spot, and loaded up....
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules