I am sorry for all the inane posts I have been making lately. I am in the mode of improving my shop in small, incremental ways and my brain is all over the place.

I have the grizzly sliding table attachment and the miter gauge it comes with has quite a bit of slop and I am required to square it to 90 every time I take it off the saw. I have tried various improvements and non has been satisfactory. I just ordered a Jessem 07150 miter gauge after reading a lot of reviews. I am hoping to continue to use the slider but replace the miter gauge with this one. This would require that I affix the miter gauge into the slot so it does not move, but I would still need to be able to easily remove it for rip cuts then reinstall. Ideas?