-
Thanks for that info, Steve.
I'm still pondering all the pros and cons and haven't made a decision.
Weather is supposed to moderate for a few days so I'd like to get out in the shop and review spacing.
I have a Warm Morning pot belly coal stove in a corner that takes a lot of space and, surprising to me, makes very little heat.
If I take it out, the RAS may fit there.
Also, that would put it by the big doors so I could open them if I needed to do longer stuff.
Boy!
That saw is heavy to even roll around.
-
Get rid of them all and buy a short stroke Euro slider, maybe even with a built in shaper. Save space, increase your capacity and accuracy.
That's what I did for a small basement shop, haven't looked back since.........Rod.
-
Thanks for the suggestion, Rod.
Perhaps if I had known about these things before I bought (or had for years) all this other stuff.
Without knowing exactly what a short stroke Euro slider is, I'm guessing it's out of my budget.
-
Wanted to update.
I decided to keep the RAS for now.
I moved it near my big door so I could handle longer stuff.
I
Also keeping the Dewalt non-slider due to it's mobility and quick set up and compact storage.
Over the last few days I had it and my table saw set up and it's a little tight getting around.
Length wise I was sort of okay but width is at a premium
Thanks for all your input
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules