I would like to get better dust collection on my table saw. I found a few older threads referencing this saw but none of them seemed to be quite applicable to what I am thinking. I also think the saw has changed over the years. I have attached some photos for those not familiar with this model.
I have a 4 inch DC hose going straight to the saw. I am thinking about modifying the blade shroud or making a new one that will allow the 4 inch DC hose to go directly to the blade shroud. I thought about plugging the two inch hole at the back and cutting a 4 inch hole parallel to the blade and attaching a fitting to that. I'd then have to cut a hole in the back of the saw to allow for the inch hose. Thoughts?
20200113_070154.jpg
20200113_070240.jpg
20200113_065945.jpg