Just acquired an old Delta Rockwell 30 C radial arm saw. I will be totally rehabbing it this spring. It is set up for 220v, motor says 14/7 amps. I have an outlet in my shop that I can use that is 220v with a 40 amp breaker. Right now I use this outlet for my Delta 3 HP 15" planer. As I would not be using my planer at the same time I would be using the RAS, anything wrong with plugging my RAS into this outlet it for use? (As an aside, I had a larger sub panel installed a couple of years ago by an electrician.) Randy