I searched but didn't find any discussions about the Laser Pecker portable engraver.
I make lots of big maple carving boards. Most are 23"x16"x2". Many times I get requests to put a specific logo on the boards. I usually make 15-20 boards in a batch.
Logo is fairly small, averaging 1" x 2". I purchase an electric branding iron for the logos. I hate using them because around ten percent of the time the logo has to be redone.
I saw Laser Pecker videos on You Tube but most seemed to be geared towards marketing instead f an actual review. Most of then reviews on Amazon have the same feel.
Is it realistic to think that I could engrave accurate, repeatable logos on maple with this $300 portable laser?
Are there better portable solutions that I should research?
Link to Laser Pecker on Amazon: https://www.amazon.com/dp/B07W5SYWSF/ref=cm_sw_r_cp_apa_i_OGZcEbKVEEG0N