Originally Posted by
Leo Graywacz
Because you have to buy a toner cartridge that is $109.00 after the original runs out.
You must have an old HP DeskJet like I do. Last time I checked, it was going to be almost $130.00 to replace both cartridges.
The aluminum extrusion is expensive. Too expensive in my mind, but it is what it is. I just think that for that cost, you should be able to butt one track up to another, tighten the clamping bars, and have a dead straight edge with the two connected tracks. Not the case though. I use a 6' Starrett machine rule to align mine.
Anybody ever re-cut the butted ends of the tracks, so that they self align without the need for some type of alignment straight edge?
"The first thing you need to know, will likely be the last thing you learn." (Unknown)