Results 1 to 3 of 3

Thread: this is the jumbo tracer 4 configuration (4 boards bolted)

  1. 12-22-2019, 4:16 PM #1
    stan kern
    stan kern is offline [OP] Contributor
    Join Date
    Nov 2009
    Posts
    1,236

    this is the jumbo tracer 4 configuration (4 boards bolted)

    I am going to trace out a large set of plans for a 18 foot canoe, sides and bottom
    and show the different selections on 2018 jumbo trace software using the jumbo 4
    configuration
    this is an amazing configuration of 4 boards tied together

    https://youtu.be/cEdn2X3fDg0 jumbo4
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  3. 12-23-2019, 12:37 AM #2
    David Buchhauser
    David Buchhauser is offline Contributor
    Join Date
    Apr 2017
    Location
    Tucson, Arizona
    Posts
    1,205
    Nice!! That's one very large digitizing board.
    David
    Reply With Quote Reply With Quote
  4. 12-23-2019, 9:22 PM #3
    stan kern
    stan kern is offline [OP] Contributor
    Join Date
    Nov 2009
    Posts
    1,236
    its amazing how the software shows 4 boards in the configuration I picked and it allows tracing over the joint between the boards by allowing you to shift the diagram over say a foot

    I am also amazed at vector quality
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules