When i set my miter saw up using a wixey gauge for accuracy, it won't stay true.
I set the vertical( perpendicular) at 90 degrees and bring the arm( blade) down not running i loose 0.3 to 0.4 of a degree. It won't stay at 90 degrees. If i move the blade to 45 degrees for a miter its the same.
On a 6 inch wide board that i am trying to make a jewelery box from, corners are junk, bad miters. They are off almost 0.025 from the top to the bottom.
I sent an email to dewalt and the response was take it to a service center.
Does anyone have a recommendation for repairs?
Thanks, abbey thomas