Drill Press Table

[Tom M King]

I bought an Ellis chuck for my magnetic drill press. I never measured runout on it, but used it to run a 16mm straight chucking reamer through some wallowed out 5/8" holes in a tractor frame, and it seemed perfectly smooth. If you need a 3MT 3/4" chuck, and don't want to spend over a couple of hundred bucks, it's pretty good.

https://www.trick-tools.com/Ellis_Dr...huck_4649_1150 I don't remember who I bought it from, but don't think it was that outfit. That was just at the top of the list of a Google Search.

[Larry Frank]

Interesting, I have the Voyager DVR with a similar keyless chuck. I measured run out at about 2 thousandths.

I put mine up on a base using a HF engine lift. The lift folds up nicely and comes in very handy from time to time