Delta 36 725

[Mike Racine]

All went together good. Only thing i have concerns with is riving knife.


Seems it loose side to side. I can push on it from the left and it moves off the blade a good 3/16. Let go and it jumps back inline with the blade
Small handle is in the locking notch but still seems loose. Is this normal or do i have a delta issue..



It will not pull out. Just side movement.


All else went good. Motor was shifted a good bit but i fixed all that.


Thoughts????

[Bill Dufour]

Has a motor so I guess it is a tablesaw not a froe or spoke shave? Did you buy it to make shingles?
Bill D.

http://vintagemachinery.org/mfgIndex...l.aspx?id=8177

https://en.wikipedia.org/wiki/Froe

[Jim Becker]

So....what exactly is a "Delta 36-725"? Enquiring minds want to know.

[Mike Racine]

10" Table Saw...………..