Cast Iron Router Table - Photos request

[Brian Holcombe]

I bought a Jet cast iron router table top this morning and while it is in transit I was wondering if someone couldn't post up a photo of the underside. I can't seem to find any photos online and I'd like to begin planning my approach to how I will attach it to the existing Incra frame and how I will attach the dust box.

Thank you
Brian

[Jim Becker]

If it's anything like my BenchDog top, there are likely threaded holes on the bottom that can be used to develop a mounting system for your frame/cabinet below. I have a thread here from "way back when" that has photos which might be helpful for you to think about this:

https://sawmillcreek.org/showthread....ight=Bench+Dog

You're really going to enjoy having that cast iron top!

[Brian Holcombe]

Thanks Jim, that is helpful!

Very much looking forward to it!

[Clint Baxter]

I bought a Jet cast iron router table top this morning and while it is in transit I was wondering if someone couldn't post up a photo of the underside. I can't seem to find any photos online and I'd like to begin planning my approach to how I will attach it to the existing Incra frame and how I will attach the dust box.

Thank you
Brian

Have you looked at the online manual, https://content.jettools.com/assets/...000_man_EN.pdf Not a lot of info there but you may find some information of use.

Clint

[Brian Holcombe]

Thank you, Clint. It did provide some illumination given that I have the same box for dust collection maybe this will be less difficult than I assume it could be.