-
My lathe motor would growl for the first few minutes when the shop was 50 or below. I changed the bearings and the problem went away. Run the motor for a few minutes and feel the bearings to see if they are too hot.(motor off obviously). Feel if belts are warm etc.
A heat gun might be a good way to locate a loose connection that overheats.
Bil lD
-
Interesting thought Lee. I'll keep that in mind. Thanks!
-
Hi, sounds like a ,slipping belt and/or a dull blade.
Are you using a rip blade for ripping?
Regards, Rod
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules