Been edge jointing a piece of cherry. Used a long wooden jointer to start, and then moved to my #62 to take the final fine shavings. Shavings are very fine, but a bit crinkly/wavy. Surface is good, so no big deal, but just wondering if this crinkly shaving is “correct” or if there may be some set up I’m missing. Iron is sharp, has a ~50 degree bevel and the mouth is about as closed as I dare.
Like I said, not freaked out about this, just wondering for my own learning.
Thanks.
D8C12FC4-F1C6-4C2E-884B-27CBDEB5AC53.jpg