I tried and tried to avoid asking for help but I am just at wits end with this. I am trying to make a flag display case. I’m cutting the angles in a tenon jig on the table saw. The saw is new to me in the last month so I’ve been spending time setting it up. Ive tuned it up and checked it multiple times now and it is dialed in. These are the results so far. The cut is skewed somehow. You can see in the pictures below how the final cut no square across the board. I marked a pencil line in the one photo that is square so you can see. And you can see in the third picture how uneven the cut is off the table.
What am am I doing wrong? The jig is PERFECTLY 90 degrees to the table in both directions. When I set up the saw I even adjusted blade to miter slot at 45 degrees and had to add a thin shim above the back two table bolts. I have tried this cut with different blades and get the same results. I’m so confused at this point. Any help is appreciated. Thanks.
Reply With Quote