Well finally got the T27 hooked up and ready for work. I was able to calibrate the spindle height, now I need to zero the fence, unfortunately, neither the manual nor video's online appear to help.
What I've used in the past is simply move the fence till it is parallel with the spindle and manually set the fence position to 1/2 of the spindle width this zero's the fence to the center of the spindle.
Well, I do not see anywhere to override the spindle position, there is a "Zero" button, but that is a relative zero, and not a way to zero the spindle...
I then tried to move the fence back to the center of the spindle by issuing a move - 1/2 width of the spindle so I could press the "Zero" button but the fence will not go back that far...
Hoping some people here might have one and let me know. I tried to program a rabbeting cutter and after I followed the screens, however, the bit was not moving to the correct width of the rabbet.
Thanks