Results 1 to 2 of 2

Thread: Elektek Rotary

  1. #1
    Join Date
    Dec 2008
    Location
    Tennessee
    Posts
    262

    Elektek Rotary

    I just purchased an Elecktek rotary for my laser, a Universal VLS230 30 watt. I have figured out the pins on the lift table that I need to jump to tell the computer that I am using a rotary device but I am not sure how to get power to the rotary tool itself. I suspect the two pins at the top
    of the connector block may
    provide either power or directions of rotation but I don't know which or how to get the other two to my rotary. The rotary itself has a 4 pin connector. The wires going to it are red, yellow, black, and white.
    I would appreciate any help in figuring out how to connect the rotary to my laser.

    Many thanks
    Randy Walker
    P.S. I've been away for a while.Its good to see so many remembered names and so many new ones
    Last edited by Randy Walker; 11-15-2019 at 11:20 AM.
    Grandpa
    Well equiped wood shop

    Universal VLS230
    Sand Carving toys

    Corel X8
    Randy Walker aka woodchuck
    Duck River Woodturners VP
    TAW member, Symposium comity member
    Volunteer Woodturners member
    Dickson Woodturners member

  2. #2
    Randy
    Welcome back!

    Sorry but I can't help with your question.
    Mike Null

    St. Louis Laser, Inc.

    Trotec Speedy 300, 80 watt
    Gravograph IS400
    Woodworking shop CLTT and Laser Sublimation
    Dye Sublimation
    CorelDraw X5, X7

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •