tracing an east coast fisherman's head to end up cutting this graphic on a vinyl cutter
Using logic trace 2018 to digitize the diagram
https://youtu.be/yX7ozCsiQvc
tracing an east coast fisherman's head to end up cutting this graphic on a vinyl cutter
Using logic trace 2018 to digitize the diagram
https://youtu.be/yX7ozCsiQvc
Nice job Stan.
What size is your graphic tablet?
The drawing board I have is 18feet by 6 feet wide, its called the jumbo board
its actually 3 drawing boards together, most of the time I only use one board
I also have 2 smaller older boards in storage (they work fine just outgrew them)
.
The jumbo setup can be 4-to 5 boards together,some large companies use 4 possibly like Boeing they use these for cutting carpets
Keith I tried to answer your message but i was not able, said i did not have the right to do so
but yes I do custom drawings for companies in the USA
They send me paper patterns and I send back the dxf files
Maybe you could send me your contact info...stan
these are better pictures , there are 2 computers for these boards the first one runs one board , the one down at the end
runs all three boards and i have software that a 4th board could be installed
The jumbo boards are good for boats say 14 foot to 16 foot which i have drawn , but most of the time I use a single board
to digitize
The software is designed to be able to re-draw where the board joints are as this is a null area , about 10 in strip right to the top