I'm trying to decide what is the best solution to my woodturning issue. Presently own a general 160 four speed lathe that i purchased in about 1995. it has been a good lathe, i mostly turn bowls and some spindle work but my spindle skill need more practice i know. Would like to have a variable speed lathe, and my two options are either sell the 160 or buy a Laguna 12-16 or install a variable speed drive on the 160. I would need a 3 phase 1725 0r 1140 RPM 1 HP 3 phase motor. This would involve a new motor, a Variable Speed Drive and associated electrical fuses, enclosure, and protection for the VFD and Motor. I could use either an AC VFD to do with a DC like Craft Supplies offers. Presently the 160 has a 1725 3/4 Hp 110 volt motor which has served me well. Anyway the work involved would definitely take some time plus about $600. or so for the motor and drive. If anyone has been there and has some suggestions i'd like to hear them, and thanks.