I'm about to set up a Jet 1hp power feeder on a Northwood shaper and will be purchasing a VFD to power it. I only installed a VFD once before and used a KBAC-24D by KB Electronics. It was easy to set up and only involved moving a few jumpers, minor wiring, etc. Someone on this forum suggested using a Fuji Frenic Mini for this application in another thread. The Fuji is attractive because of its smaller size and lower cost. However the KBAC-24D has a better enclosure, NEMA 4X versus 1 and was easy to install. Any suggestions on which way to go?