Hello,
I have a Raycus 50wt + 200*200 table.
Material: Stainless steel painted with black powder polymer paint.
A task: get smooth bright engraving.
The parameters were selected for that engraving:
- 2 loops:
Line Width - 0.05
90power\400speed\20freq\0angle
- 2 loops
Line Width - 0.05
42power\2000speed\20freq\90angle
Engraving goes well, but smooth engraving does not always go well, there are time to time lines with different shape of color in different places of engraving, I think its probably knocks out more material or I am mistaking with this. Also I remove the vibration of ventilation, it helps but sometimes still lines ((
And sometimes it’s good, there is no lines at all, and sometimes there are in different places. I already tried to change different modes, angles - the problem does not go away (
Please tell me how to solve this problem.
Thanks in advance for your reply.
05.jpg
04.jpg
03.jpg
02.jpg
01.jpg