Not much shop time today...hour here, 1/2 hour there...too many errands to run....
That Stanley No. 5-1/2 seemed to be doing more smoothing, than flattening...did a little check.
DVD Door, checking.JPG

Hmm..high in the middle? Rotate the blank 90 degrees, and go across the grain...the Stanley was a bit too heavy, so..
DVD Door, WR 62 flattening.JPG
Figured this would do the trick....
DVD Door, Flat, now.JPG
Then, added a clamp and a caul, and stashed the panel out of the way for a day or two...
DVD Door, Set aside, for now.JPG
Had a cross cut to do...
DVD Door, rail blank.JPG
to get a couple blanks for rails....and...
DVD Door, stile blank.JPG
A couple stiles...ripped on the bandsaw....was a bit tuckered out from all that plane work..
DVD Door, frame part blanks.JPG
Need to do an S4S job on these, then some grooves milled, then Mortise and tenons at the corners....to make the frame for a raised paneled Frame & Panel Door
Stay tuned...the cussing is just getting warmed up..