Results 1 to 3 of 3

Thread: Rotary set up

  1. #1

    Rotary set up

    Good afternoon,
    I am having trouble with my rotary. I just installed it on my probotix cnc. I don't think I bringing the file in the right way. The controller is a linux based unit. I saved it off as an .ngc like I always do. Should I be saving it as a different file type?
    Thanks
    Evan.

  2. #2
    Join Date
    Oct 2009
    Location
    Marquette, MI USA
    Posts
    449
    Are you using a post processor that is rotary wrapped enabled?
    Gary Campbell
    CNC Technology & Training

  3. #3
    I was trying to use the axyz that I read about other people using, but found a dedicated post processer that works wonderfully. Thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •