I have the cabinet saw add-on sliding table attachment that Grizzly sells and the problem I have is that there is a lot of slop that requires I use a square to reset it to 90 (or get any precise angle, really). It varies by about .5 degree. I have to square it up before tightening the handles. If I keep the miter bar tight there is less slop, but not much. I took apart the spring loaded stop mechanism and I did not see an easy way forward to improve that, but I am not convinced that is the only culprit. Anyone had this issue?
I like the capacity the attachment gives, but for preside angles it is easier to just use my old incra miter gauge, defeating the added capacity. Attached photos show the general setup and the two extremes I get while set at 90 degrees and the handles loosened.
20191001_211922.jpg20191001_211933.jpg20191001_211945.jpg